Administration Guides

What’s New

Home

What’s New

  1. New in 2.5.6
    1. New Dedicated Icon "Data and Config Migration"
    2. Ability to copy only configuration data from one zone to another without need a synciq policy to exist.  This can be used by entering any source path and any target path with auto access zone detection.  NOTE:  The paths must exist.  This new job type can stay and run during normal configuration task to keep config data in sync during a migration.  New check box: "Migrate only configuration" 
    3. Ability to auto detect existing syncIQ policies on the source and target path and use them to sync configuration data.  This allows the copy policy to be setup and migration of configuration can use the existing policies in place.
    4. Migration SyncIQ policies can now be selected and used in SyncIQ mode failover in the DR Assistant.  This allows the cut over to be done in Eyeglass using a one way failover.  This is only supported between 2 clusters and not between access zones on a single cluster.
  2. New in 1.9 Access Zone Migration now allows the SyncIQ policy created to persist after the initial copy and Config sync phase.  
  3. This allows for phased cutover and incremental sync of data before the final cutover to new access zone or cluster for migrated data.
  4. The Policy will appear in the Jobs windows to support incremental config sync changes as well as data sync.
© Superna LLC